Switch ⁄ Sensor

・Visualization of settings
・Simple 3-step setting
・Easy screen switching
　It is possible to change the settings while checking the measured value.
・Delay time:1.5 ms or less
・Current consumption: 25 mA or less
・IO-Link compatible

・With One-touch fitting (Straight, Elbow)
・Space saving, Capable of vertical and horizontal contact mounting
・With display calibration function
・Simultaneous copying is possible for a maximum of 10 units.

・Low profile: 9.8 mm
・Vertical mounting space reduced to approx. 1/2
　(Compared to the ZSE/ISE30A series)
・Simultaneous copying is possible for a maximum of 10 units.
・3-step setting

・Metal body type (Aluminum die-casted)
・IP67
・With M12 connector

∗ The ISE70 series was remodeled in April 2018.
　Please select the ISE70-□-L2 series.
∗ The ISE75 series was remodeled in July 2018.
　Please select the ISE77G series.
∗ The sale of the ISE75H series is continued.

・Can be integrated with ZM ejector system.

・Can be integrated with a ZX or ZR ejector system
・Comes equipped with a suction filter as standard

・Plug-in port for One-touch fittings.
・With LED light.

・Modular type mountable
・ARM10/11 series mountable
・Selectable pressure unit
・With anti-chattering function
・Power-saving mode

・16% lighter, 11% smaller (Compared with the IS1000)
・Service life: 5 million cycles
・Can be connected to modular type F.R.L. units

・Can be used for micro load, around 10 mA e.g.
・With neon light.

・Can be integrated with a ZM ejector system

・It is possible to change the settings while checking the measured value.
・IO-Link
・Angled display
　Good visibility from various mounting positions
・Rotating display
　Display can rotate 336 degrees after installation
・Applicable fluid：Air, Non-corrosive gas, Non-flammable gas (ISE70/71)
　　　　　　　　 ：Liquid or gas that will not corrode materials of parts
　　　　　　　　　 in contact with fluid (ISE7□G/79S)